Midstream Ovulation Predictor Instructions

(cap color may vary)

1. Remove the midstream test from the foil pouch and familiarize yourself with the product.

2. Remove the Cap and place it over the Thumb Grip. See the illustration above.

3. Hold the midstream test by the capped Thumb Grip with the exposed Absorbent Tip pointing downward directly into your urine stream for at least 10 seconds until it is thoroughly wet. See the illustration below.

Note: Do not urinate on the Test and Control windows. If you prefer, you can urinate into a clean and dry container, then dip only the Absorbent Tip of the midstream test into the urine for at least 10 seconds.

4. After removing the midstream test from your urine, immediately replace the Cap over the Absorbent Tip, lay the midstream test on a flat surface with the Test and Control windows facing upwards, and then begin timing.

5. As the test begins to work, you may notice a light red flow moving across the Test and Control windows. Wait at least 3 minutes for the red line(s) to appear. If no red line appears, wait one minute longer. Some positive results may be observed in 1 minute or less depending on the concentration of hCG. Do not read the result after 10 minutes.

 

INTERPRETATION OF RESULTS

	POSITIVE: Two lines are visible and the Test Line (T) is the same as or darker than the Reference Line (R). This indicates that you will probably ovulate within 24-36 hours.
	NEGATIVE: Two lines are visible, but the Test Line (T) is lighter than the Reference Line (R), or there is no Test Line. This indicates that no LH surge has been detected and you should continue daily testing.
	INVALID RESULT: Reference Line fails to appear. Insufficient specimen volume or incorrect procedural technique are the most likely reasons for an invalid result. Review the procedure and repeat the test with a new test strip.