Midstream Pregnancy Test Instructions

(cap color may vary)

1. Remove the midstream test from the foil pouch and familiarize yourself with the product.

2. Remove the Cap and place it over the Thumb Grip. See the illustration above.

3. Hold the midstream test by the capped Thumb Grip with the exposed Absorbent Tip pointing downward directly into your urine stream for at least 10 seconds until it is thoroughly wet. See the illustration below.

Note: Do not urinate on the Test and Control windows. If you prefer, you can urinate into a clean and dry container, then dip only the Absorbent Tip of the midstream test into the urine for at least 10 seconds.

4. After removing the midstream test from your urine, immediately replace the Cap over the Absorbent Tip, lay the midstream test on a flat surface with the Test and Control windows facing upwards, and then begin timing.

5. As the test begins to work, you may notice a light red flow moving across the Test and Control windows. Wait at least 3 minutes for the red line(s) to appear. If no red line appears, wait one minute longer. Some positive results may be observed in 1 minute or less depending on the concentration of hCG. Do not read the result after 10 minutes.

 

INTERPRETATION OF RESULTS

	PREGNANT: The presence of two red lines in both the test window (T) and control window (C) means you are probably pregnant. One line may be lighter than the other, they do not have to match.
	NOT PREGNANT: The presence of one red line in the control window (C) means you are probably not pregnant.
	INVALID RESULT: The result is invalid if no red line appears in the control window (C), even if a line appears in the test window (T). You should repeat the test with a new midstream test.